Lamy 2000 exploded view

[Ron Z]

 

Top - Cap.  Don't bother trying to take the cap apart.  It's been tried, and it didn't go back together.

 

Middle - section with black ring.  This may slide off on some pens.  Nib, feed, section seal, clutch, barrel

Bottom - piston with seal in place, bushing, spindle, turning knob.

 

One more picture with a closeup of the feed etc.  Note that the narrow end of the seal is in contact with the end of the collector, and the wider end is in contact with the wider nose piece.  This also means that the outside of the seal follows the taper of the section.

 

[hari317]

16 hours ago, Ron Z said:

Top - Cap.  Don't bother trying to take the cap apart.  It's been tried, and it didn't go back together.

if this is the makrolon version, it is pretty straightforward to take the cap apart and put it back together.

 

You take a wooden dowel, insert it into the cap and push on it to prevent the inner cap from rotating. Unscrew the black finial at the top of the cap. It will come off. the inner cap with the section guiding fingers will fall out. Slide up the clip. Take care of the little spring behind it.

I can post a pic over the weekend if required.  

[Ron Z]

The one I had did not unscrew.

[amberleadavis]

Thank you for sharing.

[AceNinja]

23 hours ago, hari317 said:

I can post a pic over the weekend if required.  

Since you offered, then...:  Required.  😁😁

[BrassRatt]

On 12/13/2022 at 6:55 AM, Ron Z said:

One more picture with a closeup of the feed etc.  Note that the narrow end of the seal is in contact with the end of the collector, and the wider end is in contact with the wider nose piece.

 

One more little detail:

on the  Lamy 2000 I just disassembled, the end of the collector has a slot, and the narrow end of the seal has a nub that can fit into that slot. 

[Ron Z]

Interesting.  The ones I've seen have not had this.  Maybe a design change?