Warwick Lever Filler With Screw-In Section – Is It Possible To Replace A Sac?

[alexro]

I believe that screw-in section was made to ease swap between different nibs like in Esterbrooks. But I don’t understand how one can change the old sac inside the pen. Is it possible at all?

 

 

[Pickwick]

Looks as though there is a piece missing to fit the sac. Is the old sac still in the barrel? If so there may well be the piece still attached which fits into the section.

[alexro]

Looks as though there is a piece missing to fit the sac. Is the old sac still in the barrel? If so there may well be the piece still attached which fits into the section.

The old sac is still inside the pen and I cannot take it out as it is still attached to something inside (it should be glued to something anyway). So do you think that piece is still inside? But why then it is impossible to take it out?

Edited February 21, 2014 by alexro

[watch_art]

maybe the black threaded sleeve inside the barrel is meant to be removed. Put the section back in, heat the barrel carefully, and start to pull. You might break it, but you might get the sac out, too.

[alexro]

maybe the black threaded sleeve inside the barrel is meant to be removed. Put the section back in, heat the barrel carefully, and start to pull. You might break it, but you might get the sac out, too.

Yes, I think only about this way. That sleeve just sits so tight and it looks like it wasn't supposed to be pulled out. But I will try it tomorrow. Thanks