Jump to content

Nib Replacement In Conklin Mark Twain Crescent


amberleadavis

Recommended Posts

While at the LA Pen Show, I picked up a blue Crescent filler Mark Twain. Of course, it does not have a double broad stub nib (very few pens do). So, where do I find other nibs? Are the nibs as easy to change out as the Pelikan nibs or the Esterbrook nibs (I hope so). Any help would be appreciated.

Fountain pens are my preferred COLOR DELIVERY SYSTEM (in part because crayons melt in Las Vegas).

Create a Ghostly Avatar and I'll send you a letter. Check out some Ink comparisons: The Great PPS Comparison 

Don't know where to start?  Look at the Inky Topics O'day.  Then, see inks sorted by color: Blue Purple Brown Red Green Dark Green Orange Black Pinks Yellows Blue-Blacks Grey/Gray UVInks Turquoise/Teal MURKY

 

 

 

 

 

 

Link to comment
Share on other sites

  • Replies 15
  • Created
  • Last Reply

Top Posters In This Topic

  • SteveE

    4

  • amberleadavis

    4

  • Otherwise

    2

  • rosalita

    2

I've used the nib from my modern Conklin Mark Twain in a Jinhao x750, so I think it's safe to assume that any standard Jowo #6 (such as Goulet, Edison, Monteverde, Nemosine) or Bock 250 could go the other way. Hope that helps.

Link to comment
Share on other sites

You are wonderful! Thanks.

Fountain pens are my preferred COLOR DELIVERY SYSTEM (in part because crayons melt in Las Vegas).

Create a Ghostly Avatar and I'll send you a letter. Check out some Ink comparisons: The Great PPS Comparison 

Don't know where to start?  Look at the Inky Topics O'day.  Then, see inks sorted by color: Blue Purple Brown Red Green Dark Green Orange Black Pinks Yellows Blue-Blacks Grey/Gray UVInks Turquoise/Teal MURKY

 

 

 

 

 

 

Link to comment
Share on other sites

I agree - most (all?) of the available #6 nibs should fit. I have a 2004 Mark Twain Crescent that is now sporting a Knox steel nib. The pen and I are both very happy.

 

Virtually any of the modern Conklin pens can use a #6 nib. Maybe there are a couple that are smaller, but the dozen or so pens that I have all use #6.

 

The nib can be just pulled out of the section along with the feed. Match your new nib to the feed and re-insert. Watch for the "flat spot" on the nib and in the collar that remains in the section to ensure proper alignment.

Link to comment
Share on other sites

This is good info. I have a Conklin Mark Twain crescent filler and got a 1.1 stub nib as I wanted to try it out. I'd used a sample of that nib on another pen and thought it was ok. But on the pen I got, it seemed to write too wide a line. So either I'll swap it out for a plain Jane medium or have a nibmeister adjust its flow.

Link to comment
Share on other sites

White Lotus, I'll send you mine to test out first. Maybe we should swap nibs. The nib I have is beautiful but it's not an obscenely wet overly broad nib.

Fountain pens are my preferred COLOR DELIVERY SYSTEM (in part because crayons melt in Las Vegas).

Create a Ghostly Avatar and I'll send you a letter. Check out some Ink comparisons: The Great PPS Comparison 

Don't know where to start?  Look at the Inky Topics O'day.  Then, see inks sorted by color: Blue Purple Brown Red Green Dark Green Orange Black Pinks Yellows Blue-Blacks Grey/Gray UVInks Turquoise/Teal MURKY

 

 

 

 

 

 

Link to comment
Share on other sites

I have the same blue yellow Crescent filler. I tried the Goulet 1.1 stub on it, but the feed couldn't keep enough ink flowing in mine, for me. But the "surgery" is fast and painless.

To hold a pen is to be at war. - Voltaire
Link to comment
Share on other sites

Thanks, Ted!!

Fountain pens are my preferred COLOR DELIVERY SYSTEM (in part because crayons melt in Las Vegas).

Create a Ghostly Avatar and I'll send you a letter. Check out some Ink comparisons: The Great PPS Comparison 

Don't know where to start?  Look at the Inky Topics O'day.  Then, see inks sorted by color: Blue Purple Brown Red Green Dark Green Orange Black Pinks Yellows Blue-Blacks Grey/Gray UVInks Turquoise/Teal MURKY

 

 

 

 

 

 

Link to comment
Share on other sites

  • 2 months later...

::eyes the extra fine Goulet nib that was purchased 'just in case' for a Neponset, and emits 'Delighted SuperVillain Cackle Of Gleeful Anticipation Of Imminent Mayhem' #9::

 

My Crescent is a lovely pen, and it holds a worthy amount of ink - I just feel like I'm dragging the broad edge of a garage door around the surface of the paper with that medium nib that's on it. I'd like to get that down to a kitchen cabinet door, (or a dry Japanese fine ), if I could...

As kids, some girls wanted to be princesses. I wanted to be Morticia Addams. Or Nikola Tesla. Preferably both.

Link to comment
Share on other sites

::eyes the extra fine Goulet nib that was purchased 'just in case' for a Neponset, and emits 'Delighted SuperVillain Cackle Of Gleeful Anticipation Of Imminent Mayhem' #9::

 

My Crescent is a lovely pen, and it holds a worthy amount of ink - I just feel like I'm dragging the broad edge of a garage door around the surface of the paper with that medium nib that's on it. I'd like to get that down to a kitchen cabinet door, (or a dry Japanese fine ), if I could...

 

You could try an Extra Fine Knox K35 nib from xfountainpens.com. I've not tried an extra fine, but I've used the fine and medium Knox nibs in modern Conklin pens with great results. (Usual disclaimers - I have no affiliation with either xfountainpens or Conklin Pen Co.)

Link to comment
Share on other sites

I apologize if this is dragging the thread too far off-topic, but I just got a Conklin Twain Crescent and have been contemplating the best/easiest way to clean it (I know I haven't even inked it up yet but I like to plan ahead). Obviously I can't use my usual method of a bulb filler or syringe since the body doesn't open, but is there any option to the standard fill-flush-repeat method? I was wondering since the nib is so easily removed if there was a way to get at things from that end, but I am pretty new to FPs and don't want to mess anything up.

 

And if this is better posted elsewhere, please feel free to tell me to move it! I'm still learning my way around FPN.

Link to comment
Share on other sites

You could try an Extra Fine Knox K35 nib from xfountainpens.com. I've not tried an extra fine, but I've used the fine and medium Knox nibs in modern Conklin pens with great results. (Usual disclaimers - I have no affiliation with either xfountainpens or Conklin Pen Co.)

Thank you, SteveE! That's a good idea: I've ordered an extra fine from xfountainpens. :). This way, I'll have the original nib for the Neponset, and still be able to stop subjecting innocent (and not so blank) sheets of paper to the tender ministrations of garage doors. :)

As kids, some girls wanted to be princesses. I wanted to be Morticia Addams. Or Nikola Tesla. Preferably both.

Link to comment
Share on other sites

rosalita - As you have surmised, the simple "fill with water, empty, repeat until water is clear" is the standard way to clean sac pens (lever-fillers and the crescent fillers). I am presuming that you only want to clean the pen enough to change inks, not to make it clean enough to perform surgery on your first-born child. I'm only slightly kidding - if you just want to keep the pen clean enough to work properly and to change inks, just flush it out with water until the water runs out clear. I am not a proponent of trying to clean my pens so that they are surgically clean, as I believe that they were never meant to be cleaned that way.

 

You're on the right track. If you did want to make your pen super-perfectly clean, then I'm not the best person to help, as I just don't do that.

Link to comment
Share on other sites

rosalita - As you have surmised, the simple "fill with water, empty, repeat until water is clear" is the standard way to clean sac pens (lever-fillers and the crescent fillers). I am presuming that you only want to clean the pen enough to change inks, not to make it clean enough to perform surgery on your first-born child. I'm only slightly kidding - if you just want to keep the pen clean enough to work properly and to change inks, just flush it out with water until the water runs out clear. I am not a proponent of trying to clean my pens so that they are surgically clean, as I believe that they were never meant to be cleaned that way.

 

You're on the right track. If you did want to make your pen super-perfectly clean, then I'm not the best person to help, as I just don't do that.

 

Thanks, Steve, and you are exactly right — I just want to get it clean enough to not have muddy ink colors when I switch. It's funny how for years I was perfectly happy with the "fill with water, empty, repeat until water is clear" method until someone showed me the trick of the bulb filler. I've become spoiled. :-)

Link to comment
Share on other sites

  • 2 weeks later...

So just curious - is it a friction nib?

 

I think there is a collar in there, but you can pull the nib and feed out of the pen, leaving any collar behind. Then you can re-install a nib and feed the same way.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now







×
×
  • Create New...